|
||
|
![]() |
![]() |
HTC Wildfire Todo sobre el hermano pequeño de la Desire |
![]() |
|
Herramientas |
#1
|
||||
|
||||
Wipe Battery Stats
Hola, alguno habeis probado a usar la opcion del recovery de borrar las stats de la bateria?, nose donde me parecio leer que habia que hacerlo con cada cambio de rom, cual es el proceso?
Gracias |
|
#2
|
||||
|
||||
Yo lo hago cada 10-15 recargas, así se alarga un poco tanto la vida de la batería como la duración de la misma, o eso dicen...
SAlu2 |
#3
|
||||
|
||||
Y como lo haces cob la bateria llena,cable de corriente puesto explicame el proceso anda
Sent from my HTC Wildfire using Tapatalk |
#4
|
||||
|
||||
Primero de todo esperar a que se acabe la batería, al 0%. Luego entras al recovery y haces el WIPE, y después lo dejas cargando apagado durante toda la noche (8h. o más).
SAlu2 |
Gracias de parte de: | ||
#6
|
||||
|
||||
Segun CM: Battery recalibration If you're experiencing higher than normal battery drain, try the following: 1. Charge the device to full battery; let it keep charging until the battery says it is fully charged. Do not just wait until the light is green, it isn't always fully charged , causing a lot of inaccuracies . (You can check by going to: Settings » About device » Status » Battery Level = Full. ) 2. Boot to recovery mode and delete the battery stats NOTE : To have the most accurate of battery stats, reboot the device immediately after wiping the battery stats and wait for CyanogenMod to boot completely to the desktop. Once your entire boot is done and you have full access to the device, go ahead and pull the charger and continue with this troubleshooter . 3. Do not charge the device until after draining the battery completely, resulting in it automatically shutting off. 4. Recharge the device completely and then use as you normally would. |
Gracias de parte de: | ||
#7
|
||||
|
||||
alguien puede aclarar esto¿? alguien q este puesto en el tema
|
#8
|
||||
|
||||
Solo si ves ciclos de batería raros. 1º Dejo que este al 100% 2º Voy al Recovery y hago un Wipe Battery Stats, ahora quito el cargador. 3º Enciendo y dejo que se descargue con un uso normal. 4º Vuelvo a cargarlo al 100%. De todas formas puedes probar con "Battery Calibrator Pro" que esta en el Market. Si es de pago te paso el enlace. Un saludo. |
![]() |
![]() |
||||||
|