Cita: Originalmente Escrito por
JMTM13
Como se entra en bootloader y luego en shipped mode??? Explicalo por favor para los que tenemos el mismo problema. Gracias
Blinking Battery Indicator
Another common problem is a blinking battery indicator on the FSTN display. This usually corresponds with the sensors not working. We suspect this is due to the water getting into the watch as Mobvoi support asks if you have showered with the watch and users have indicated this sometimes happens after showering.
On potential fix is to drain the speaker:
With the LED display on, keep the bottom button pushed
Choose “Speaker Draining” from menu
Repeat 2-3 times, you may see some water droplets come out of the speaker holes I did it 2-3 times and I saw a little droplet right out of the speaker holes
Sensors Not Working
In many cases the sensors will stop working on the Pro 3. One potential fix is to enter Shipping Mode, as per the following instructions:
Hold the lower button while rebooting to get to Bootloader Mode
In Bootloader Mode select “Shipping Mode”.
If “Shipping Mode” is not available, select “Recovery Mode” and reboot. When you get to the Bootloader again, “Shipping Mode” should be available.
Reboot the watch. You should shut it down one more time and when you turn it back on, the sensors should be working
Another potential solution is to drain the battery fully, then recharge. This may get the sensors to start working again.