[ CONSULTA ] Cube i6 y power saving mode

[josanqui]

Buenas, tengo un problema con esta tablet, cuando se apaga luego no hay huevos a encenderla a no ser que sea con la corriente... Desde gearbest me dicen esto:

Regarding the tablet please follow these steps:
1) Charge the device for at least 6 hours and see if the device powers on normally: please try to charge using the mains AC and also via USB.
2) If this does not work, please use a needle to carefully press the pinhole-shaped hole on the side of the tablet to perform a factory reset.
3) The supplier makes an energy-saving protection function for this tablet. After the power of tablet runs out and automatically powers off, the tablet automatically starts energy-saving protection function, so tablet has no response of charging and can't be powered on.

We need long press the Power button to wake up the battery.
Please connect the power, then long press the Power button above 30 ~ 50 seconds, and recharge 10 ~ 15 minutes, the tablet can be powered on.

When you have done above, you can press and hold the power button + volume down key to recovery your phone.
Finally, if you hava done above, you only to flash the system.
Once you have tried the steps above, please feel free to reply to this message if it still does not work.
We will our best to help you for this product issue.

Cuando te pilla fuera de casa pues ya veis que es imposible utilizarla... Alguno sabe como desactivar ese modo!?