[3navis]

 Cita: Originalmente Escrito por migelo

Hecho, con el hardSpl que me facilitaste, pero es igual, me ocurre lo mismo, ¿hare algo mal? quito la bateria, enciendo, (tricolor) reseteo (tricolor), ejecuto el hardSpl, acepto y empieza normal hasta que se pone la barra al 0% unos minutos y "zas" error 262 update error. y van 44 veces. En fin. salu2.

he encontrado esto:

# Symptoms #

- ROM flash started and stopped at 17%. After recovery flash process stucks at 0% and pops Connection Error 262. Device is stuck in bootloader mode not possible to flash anything, hard reset does not help, flash from SD card does not help either.

# Possible cause for that #

1. In bootloader mode device shows:
Code:
Pola100
SPL-1.25.0000
CPLD-2
means that Hard SPL was not flashed before flashing ROM file (if Hard SPL was flashed then in second line will be written SPL-2.20.Olinex.).

2. Connection between ActiveSync and device was not established when flashing ROM file.


Before to go any further please take your time and read Polaris Wiki to get familiar with glossary and acronyms used here.

PROCEED ONLY if flashing original ROM does not help, hard reset does not help and flash from SD card does not work.


# Solution #

1. Download MTTY software.
2. Kill ActiveSync (Press Ctrl-Alt-Del and stop rapimgr.exe and wcescomm.exe processes).
3. Plug Polaris into usb port (Plug directly not through hubs).
4. Start MTTY after chose USB from PORT dropdown list (if it is not listed there then ActiveSync processes were not stopped).
5. in window type: set 16 0 (enter cmd mode)
6. after type: task 8 (this will format phone)
7. after type: task 0 (this will restart phone. Not always necessary)
8. soft reset

Otra posibilidad es el Sistema operativo, lo estas probando con Windows XP o Vista?

Salu2