de hecho esta en "hw_config.sh"
Código:
# LMU AS3676 Configuration
dev=/sys/devices/i2c-0/0-0040/leds
echo 1,40,255,35,35,1,100 > $dev/lcd-backlight/als/curve # ALS curve display BL [grp],[Y0],[Y3],[K1],[K2],[X1],[X2]
echo 2,85,0,128,128,200,201 > $dev/button-backlight-rgb1/als/curve # ALS curve key LED 1 [grp],[Y0],[Y3],[K1],[K2],[X1],[X2]
echo 2,85,0,128,128,200,201 > $dev/button-backlight-rgb2/als/curve # ALS curve key LED 2 [grp],[Y0],[Y3],[K1],[K2],[X1],[X2]
echo 3,100,255,21,21,10,100 > $dev/red/als/curve # ALS curve RGB(red) [grp],[Y0],[Y3],[K1],[K2],[X1],[X2]
echo 3,100,255,21,21,10,100 > $dev/green/als/curve # ALS curve RGB(green) [grp],[Y0],[Y3],[K1],[K2],[X1],[X2]
echo 3,100,255,21,21,10,100 > $dev/blue/als/curve # ALS curve RGB(blue) [grp],[Y0],[Y3],[K1],[K2],[X1],[X2]
echo 1,2,2,0 > $dev/lcd-backlight/als/params #[gain],[filter_up],[filter_down],[offset]
echo 1 > $dev/lcd-backlight/als/enable #Sensor on/off. 1 = on, reg 90h
echo 1 > $dev/button-backlight-rgb1/als/enable #Sensor on/off. 1 = on, reg 90h
echo 1 > $dev/button-backlight-rgb2/als/enable #Sensor on/off. 1 = on, reg 90h
echo 1 > $dev/red/als/enable #Sensor on/off. 1 = on, reg 90h
echo 1 > $dev/green/als/enable #Sensor on/off. 1 = on, reg 90h
echo 1 > $dev/blue/als/enable #Sensor on/off. 1 = on, reg 90h
echo 900 > $dev/button-backlight-rgb1/max_current #Max current in uA
echo 900 > $dev/button-backlight-rgb2/max_current #Max current in uA
La parte roja es la que controla el brillo automatico, quiza cambiando los valores a "0" se desactive el brilo automatico
en el xperia Ray en GB tenian los valores en "0" por defecto y hacian un cambio para activar el brillo automatico
Lo pruebo cuando tenga tiempo y aviso