Hola Karla.
Aquí te adjunto el mejor HardSPL, la versión
3.29. Esta versión es la que mejor se adapta con las ROMs con WinMo 6.1. Comprobado al 100 %.
...........
Instrucciones:
How to Install 3.2x.Hard SPL:
1. Plug the device into your PC
2. Copy Jump/Soft to your device. use JumpSPL If you have the "White Screen" issue, if you don't, you can use SSPL-KAIS.exe.
3. Take out your SD card & SIM Card.
4. Run Jump/Soft SPL on your device
5. Wait for the bootloader screen to appear and "USB" to show.
6. Right-click activesync, go into connection settings and ensure Allow USB Connections is unchecked
7. Unplug your device from the USB port, wait 5 - 20 seconds, plug it back in.
8. Run KaiserCustomRUU.exe and flash the SPL
If you have problems with the above process, try this:
1a. download the attached files
1b. pull out the battery and reinsert it (this step *is* important)
1c. connect your PC to phone with a USB cable
2. REMOVE SIM and SD CARDS !!
3. copy JumpSPL1.56-KAIS.exe to your device and run it (make sure the USB cable is still connected). If you still get a white screen then reset your device and now try JumpSPL1.93-KAIS.exe
4. after a few seconds "USB" appears on the phone display
5. unplug and replug the usb cable
6. deselect "Allow USB connections" in Activesync connection settings
7. now flash hardSPL (run KaiserCustomRUU.exe from flash-hardSPL.zip on your PC)
Notes:
With the JumpSPL you should *not* flash radio roms, OS roms or full roms. The JumpSPL is only needed to flash a HardSPL (or SPL)
Más información aquí:
http://forum.xda-developers.com/showthread.php?t=396922
.........
Saludos.
