Cita:
Originalmente Escrito por granansar
Hola chicos, tengo un problema, no parece que sea el beep de que se ha brickeado, así que os pregunto por si alguien sabe que pasa...
|
Con estos pasos parece que han solucionado.
1 Make sure your memory card is FAT32 format - usually any 32GB and below will be (I don't know if this works with exFAT)
2 Basically download the full 1.0 firmware from here -
https://mega.co.nz/#!VR0DlTIS!xdpKWT...9ks5mii0-jXfyo (It's a self unpacking executable so you may need to adjust browser settings to make sure it comes down ok.)
3 Once that comes down and runs you will have a file named 1.0.0YDXJv22_1.0.0_build-20150228224521_b630_i446_s638.bin on your Windows desktop.
4 Rename that to yifirmware.bin
5 Copy the yifirmware.bin file to the root \ top level of your memory card
6 Download autoexec.ash from
https://mega.co.nz/#!5dMS0TST!HtyrSP...1s9-ycs9nTcgMk
7 Copy this autoexec.ash to the top level of your memory card
8 Eject memory card from Windows - important to make sure all is ok on the card
9 Insert card into Yi
10 Connect Yi to power source
11 Turn on Yi
12 The camera will start beeping about once a second - leave this - the script now has a poweroff command so in theory the beeping may stop once it's completed - it may take over 5 minutes. Once it's completed it will delete the autoexec.ash and yifirmware.bin files and create a progress.txt
13 Put the card back into the computer and check if the yifirmware.bin files are still there - they should not be - also check progress.txt - this should show multiple entries and finish at 100%
14 See if the camera powers on - it should after power is removed and readded.