Ver Mensaje Individual
  #1  
Viejo 31/03/14, 11:59:19
Array

[xs_avatar]
jar229 jar229 no está en línea
Vendedor verificado
· Votos compra/venta: (277)
 
Fecha de registro: ene 2012
Localización: Santander
Mensajes: 27,036
Modelo de smartphone: Honor Magic 6 Lite 5G
Tu operador: Jazztel
CUBE U30GT-H by CyberianIce (4.1.1 ported from BlueBerry NetCat M12)


  • Based on latest original Cube U30GT-H ROM debranded from BlueBerry NetCat M12
  • Tested on many CUBE U30GT-H devices
  • Debloated
  • Removed China
  • Custom tuned Kernel for optimum performance and stability (up to 15k points in AnTuTu Benchmark)
  • Increased /data partition size to 2GB instead of 1GB (reduced internal sdcard partition to 12.5GB instead of 13.5GB)
  • NetCat BootSplash
  • Custom android bootanimation.zip
  • Fully working CWM Recovery 6.0.2.7


HOWTO:
1. Shut down your tablet and start it by holding down Volume + button and insert USB Cable with PC. RK Device will apear, if you have no drivers you can find them in archive.
2. Navigate to RKDevelopTool_v1.35 folder and run RKAndroidTool.exe
3. Click Erase IDB and wait for finish
4. Click Run and wait for finish
5. After procedure is complete, if your tablet don't start automatically in CWM, remove USB and shut down tablet by holding POWER button for 8 seconds (you will hear silent *click* sound from tablet as signal it's off). Now download CWM Base from this XDA post put tablet in download mode (VOL+ and USB CABLE) and flash this recovery (run RKAndroidTool.exe, push Flash ROM button). It is very same recovery from this ROM, but after this flashing is finished, tablet will boot into CWM automatically on it's own.
6. Now install ZIP files from after_install folder via CWM recovery. Format NAND is required if you first time using 2GB Data mod, and int2ext is required for some devices which reported switch between internal and external SD card. You must use an external SD Card for flashing ZIPs and search for files in both internal and external sd card in CWM as you still dont know how CMW see your SD card.
7. Reboot System. All done!




Note: If you are used increase /data to 2GB MOD before, you can just install this firmware via RKAndroidTool. If your /data partition was 1GB before, you may need to install patches from folder after_install via CWM recovery.

Más info: http://www.flashmyandroid.com/forum/...-NetCat-M12%29

Descarga: https://drive.google.com/file/d/0B1x...it?usp=sharing

-----------------------------

Testeada y el rendimiento general es estupendo
Como inconveniente, no es tan compatible con los juegos de Gameloft como otras ROM's (por ejemplo la Feriross).
Si arreglaran ese tema, la verdad es que sería genial
Responder Con Cita