Puede alguien que sepa ingles traducir las instrucciones?
Flash-Instructions (be aware: it is your own risk!)scroll to reboot system and hold Power Button until reboot (kernel allows no reboot)
- if somethings goes wrong: Hard Power-Off (hold Power for 12 sec) or Reset
ENJOY!
0) prerequisites
a) best is to use a win7 PC; do not use USB3.0 ports
b) make sure you use the Pipo P9 USB cable
1) preparation
a) decompress the download pack to the root-folder (C
of your PC
b) connect your Pipo P9 with the power supply and with the PC via USB cable
2) installation of the USB driver
a) boot your Pipo P9 and enable USB-Debugging in developer options
b) run DriverInstall.exe
c) click Uninstall Driver
d) click Install Driver
3) start your Pipo P9 into flash-modus
a) run AndroidTool.exe with admin rights
b) click Switch > status "Found One LOADER Device"
alternatively: Power-Off, hold Power and Esc until "Found One LOADER Device" is shown
4) flash the firmware with AndroidTool
a) click Lower Format
b) click Run
c) stock recovery will format the NAND
d) wait 2 minutes
5) flash TWRP or CWM recovery with AndroidTool
a) click Switch
b) untick everything other than Parameter
c) tick TWRP or CWM
d) click Run
6) start/exit of TWRP or CWM
- start via app RebootMenue (Reboot Recovery)
- start via button: unplug all cable and Power-Off; hold Power and Esc
- exit TWRP via Reboot > System
- exit CWM: